NEC Electra Elite IPK II General Description Manual page 132

Document Revision 1
J
J
Base Station
The Base Station provides the link between the IPK Wireless – DECT telephone and
the Electra Elite IPK II system. Base Stations are connected to the BSU( )-U20 ETU
using standard two wire (twisted pair) telephone cable, CAT 4 or CAT 5. The
maximum distance from the BSU( )-U20 ETU to the Base Station is 3,280 feet. Local
power is not required because the Base Station receives power from the IPK II
system. Up to 16 Base Stations can be connected to the system. Each Base Station
supports four simultaneous IPK II Wireless – DECT traffic channels at 32 Kbs.
Repeater
The Repeater allows extended coverage for low traffic areas not covered by a Base
Station. Sufficient coverage for the main traffic area should be provided by the Base
Station. An external antenna can also be connected to extend the coverage area.
Local power is required for the Repeater (within 6 feet) and must be synchronized
with a Base Station in the zone providing coverage. The Repeater is synchronized
with the Base Station using the Repeater Programming Kit that provides an RS232
cable to connect the Repeater to a PC. A Windows application is used to define the
Base Station that should be synchronized with the Repeater. Each Repeater can
support two simultaneous IPK Wireless – DECT traffic channels at 32 Kbs. As the
Repeater is paired with the Base Station, these are not additional channels, but are
available to handle calls from the Base Station as the user moves out of range from
the Base Station to the Repeater area. Repeaters should be placed a minimum of 75
feet line of sight between each other to prevent problems with the channels in use.
2 - 86
Automatic Off-Hook
B-Answer can be turned On/Off using > and < in the profile setup. When set to
On, the telephone automatically goes off-hook when it rings.
R-Key for Transfer and Special Services
When off-hook, press R to Recall, transfer.
Electra Elite IPK II
Features