Siemens Sinumerik 802D sl Programming Manual page 65

04.07
Creates
Reset behavior
If all frames are created, it is no longer necessary for the ISO mode that the fra-
mes are configured using the FINE component. The machine data 18600:
$MN_MM_FRAME_FINE_TRANS need not be set to "1". If you switch from the
ISO mode to the Siemens mode and if the Siemens mode uses a function which
requires a fine offset (e.g. G58, G59), $MN_MM_FRAME_FINE_TRANS must re-
main "1".
© SIEMENS AG 2007 All rights reserved
SINUMERIK 802D sl/840D sl840D/840Di sl/840Di/810D ISO Turning - - 04.07 Edition
$MC_MM_SYSTEM_FRAME_MASK Bit 1 = 1
Delete frame
$MC_CHSFRAME_RESET_MASKBit 1 = 0
Movement Control Commands
3.1 The coordinate system
3-65