Siemens Sinumerik 802D sl Programming Manual page 207

04.07
10185
MD number
Default setting:
Change effective after POWER ON
Data type: STRING
Meaning:
10816
MD number
Default setting:
Changes effective after Power ON
Data type: DOUBLE
Meaning:
10817
MD number
Default setting:
Changes effective after Power ON
Data type: STRING
Meaning:
© SIEMENS AG 2007 All rights reserved
SINUMERIK 802D sl/840D sl840D/840Di sl/840Di/810D ISO Turning - - 04.07 Edition
EXTERN_M_NO_MAC_CYCLE_NAME
UP name for M function macro call
Minimum input limit:
Protection level:
Cycle name when calling via the M function defined with $MN_EXTERN_M_NO_MAC_CY-
CLE[n].
EXTERN_G_NO_MAC_CYCLE
Macro call with G function
Minimum input limit:
Protection level:
G number with which a macro is called.
The name of the subprogram is specified in
$MN_EXTERN_G_NO_MAC_CYCLE_NAME[n].
If the G function defined with $MN_EXTERN_G_NO_MAC_CYCLE[n] is programmed in a
parts program block, the subprogram defined in EXTERN_M_NO_MAC_CYCLE_NAME[n]
is started, all the addresses programmed in the block are written to the associated $C_xx
variables.
If a subprogram call is already active via a M/G macro or an M substitution, no subprogram
call will be executed. If a standard G function is programmed in this case, it will be
executed, otherwise alarm 12470 is output.
$MN_EXTERN_G_NO_MAC_CYCLE[n] is only effective in external language mode G291.
A block can only contain one subprogram call, i.e. only one M/G function substitution may
be programmed in a block and the block must not contain any additional subprogram (M98)
or cycle call.
A subprogram return jump or end of parts program is not allowed in the same block. Alarm
14016 is output in the event of a conflict.
EXTERN_G_NO_MAC_CYCLE_NAME
Subprogram name for G function macro call
Minimum input limit:
Protection level:
Cycle name if called with G function defined with $MN_EXTERN_G_NO_MAC_CYCLE[n].
Machine and Setting Data
D.1 Machine/Setting Data
Maximum input limit:
Unit: - -
Applies with effect from SW version:
Maximum input limit:
Unit: - -
Applies with effect from SW version: 6.3
Maximum input limit:
Unit: - -
Applies with effect from SW version: 6.3
D-207