(With Powerline 7.04.02 Or Solution Line 1.4 And Higher) - Siemens Sinumerik 802D sl Programming Manual

04.07
Example
X
150
60
Fig. 3-4
Note
Siemens frames and ISO dialect workpiece coordinate systems are using a com-
mon storage area. In other word, changing a frame in Siemens mode will effect the
relevant workpiece coordinate system used in ISO dialect mode.
ISO Dialect mode
G54
G55
G56
G57
G58
G59
G54 P1 ... 48
G54 P49 ... !00
G92
3.1.6 Uncoupling the frames between the Siemens and the ISO mo-
des

(with powerline 7.04.02 or solution line 1.4 and higher)

In the ISO mode, various G codes occupied the programmable frame $P_FRAME,
the settable frame $P_UIFR and three base frame $P_CHBFRAME[ ]. If you
switch from the ISO mode to the Siemens mode, these frames will not be available
to the user of the Siemens language. This pertains to:
G52 Programmable zero offset --> progr. frame $P_PFRAME
G51 Scaling --> progr. frame $P_BFRAME SCALE
G54--G59 Zero offset --> settable frame $P_UIFR
© SIEMENS AG 2007 All rights reserved
SINUMERIK 802D sl/840D sl840D/840Di sl/840Di/810D ISO Turning - - 04.07 Edition
X' G55 workpiece coordinate system
90
Tool position
A
90
100 190
Setting of coordinate system with incremental values (G code system A)
Movement Control Commands
3.1 The coordinate system
Z' New workpiece coordinate system
Z Original workpiece coordinate system
Siemens mode
G54
G55
G56
G57
G505
G506
G507 ... G554
G ...
Basic frame
3-61