Siemens Sinumerik 802D sl Programming Manual page 32

Commands Calling Axis Movements
2.1 Interpolation commands
Example
N10 G1 X10. Z100. F1000 G18
N20 A140 C7.5
N30 X80. Z70. A95.824, R10
Fig. 2-11
Restrictions
ISO dialect mode
Address C is used in ISO Dialect mode both as an axis identifier and as an identi-
fier for a chamfer on the contour.
Address R can be a cycle parameter or an identifier for the radius in a contour.
In order to distinguish between these two options, a "," must be placed in front of
the C or R address during contour definition programming.
2-32
X
(X80, Z70)
(X70, Z50)
Radius = 10
Fase = 7,5
X31, Z75)
3 straight lines
SINUMERIK 802D sl/840D sl840D/840Di sl/840Di/810D ISO Turning -- 04.07 Edition
95.824 Grad
R
1
140 Grad
(X10, Z100)
Y
© SIEMENS AG 2007 All rights reserved
04.07