Siemens Sinumerik 802D sl Programming Manual page 63

04.07
Notice
If the new frames are created, the ISO G codes will write to these frames; if they
are not created, the frames are written as described in Section 3.1.5.
The tables on the following pages illustrate which G codes write to which frames,
how they are created and how the reset behavior of the frames must be set to
achieve a compatible behavior to the ISO mode original. The reset behavior can be
set deviating from the ISO mode original using the MDs mentioned above. This
can be necessary when switching from the ISO mode to the Siemens mode.
G51: Scaling
G51 X10 writes to
Component
Creates
Reset behavior
G52:Programmable zero offset
G52 X10 writes to
Component
Creates
Reset behavior
G54 - - G59 P1...100: Settable zero offset
G52 -- G59
Component
Creates
Reset behavior
© SIEMENS AG 2007 All rights reserved
SINUMERIK 802D sl/840D sl840D/840Di sl/840Di/810D ISO Turning - - 04.07 Edition
$P_ISO4FRAME
TRANS, SCALE
$MC_MM_SYSTEM_FRAME_MASK Bit10 = 1
Delete frame
$MC_CHSFRAME_RESET_MASKBit 10 = 0
$P_PFRAME
TRANS
Always present
Is deleted in case of RESET
$P_UIFER
TRANS
Always present
G54 is active after RESET
$MC_EXTERN_GCODE_RESET_VALUES[13] = 1
Movement Control Commands
3.1 The coordinate system
3-63