Siemens Sinumerik 802D sl Programming Manual page 209

04.07
10882
MD number
Default setting: - -
Changes effective after Power On
Datentype: STRING
Meaning:
10884
MD number
Default setting: 1
Changes effective after POWER ON
Data type: BOOLEAN
Meaning:
© SIEMENS AG 2007 All rights reserved
SINUMERIK 802D sl/840D sl840D/840Di sl/840Di/810D ISO Turning - - 04.07 Edition
NC_USER_EXTERN_GCODES_TAB [n]:0...59
List of user- -specific G codes of an external NC language
Minimum input limit: - -
Protection level: 2/2
Code B is implemented by default for external programming language ISO Dialect0- -T.
Code
A and Code C have different G function names.
$MN_NC_USER_EXTERN_GCODES_TAB can be used to rename the G functions.
The G command codes can be changed for external NC languages. The G group and the
position within the G group remain the same. Only the G command codes can be changed.
Up to 30 code changes are possible. Example:
$MN_NC_USER_EXTERN_GCODES_TAB[0]="G20"
$MN_NC_USER_EXTERN_GCODES_TAB[1]="G70"
- -- -> G20 is reassigned to G70;
If G70 already exists, an error message appears on NCK reset.
EXTERN_FLOATINGPOINT_PROG
Valuation of programmed values not containing a decimal point
Minimum input limit: 0
Protection level: 2/7
This machine data is effective for external programming languages, i.e. if
MD 18800: MM_EXTERN_LANGUAGE = 1.
The machine data defines how programmed values without decimal points are evaluated.
0: Standard Notation: Values without decimal points are interpreted in internal units
IS- -B, IS- -C (see MD EXTERN_INCREMENT_SYSTEM).
Values without decimal points are interpreted in internal units
e. g. X1000 = 1 mm (with 0.001 mm input resolution)
X1000.0 = 1000 mm
1: Pocket Calculator Notation: Values without decimal points are interpreted as mm,
inch or degrees.
Values without decimal points are interpreted as mm, inch or degrees
e.g. X1000 = 1000 mm
X1000.0 = 1000 mm
Machine and Setting Data
D.1 Machine/Setting Data
Maximum input limit: - -
Unit: - -
Applies with effect from SW version: 5
Maximum input limit: 1
Unit: - -
Applies with effect from SW version: 5.2
D-209