04.07
End point
The end point can be specified in either incremental or absolute values correspon-
ding to the designation of G90 or G91.
If the specified end point is not on the specified arc, the arc radius is gradually
changed from the start point to the end point to generate a spiral so that the end
point lies on the specified arc.
Example of programming
G01 Z100. X0 F10.;
G03 Z--50. K--100.;
Example of programming
G01 Z50. X0;
G03 Z--100. K--50.;
Fig. 2-7
© SIEMENS AG 2007 All rights reserved
SINUMERIK 802D sl/840D sl840D/840Di sl/840Di/810D ISO Turning -- 04.07 Edition
--100.
Interpolation with end point off the specified arc
Commands Calling Axis Movements
2.1 Interpolation commands
(a) End point positioned inside the circumference
100.
X
--50.
0
--100.
(b) End point lying outside the circumference
50.
--50.
0
50.
--50.
Z
100.
Z
2-29