Siemens Sinumerik 802D sl Programming Manual page 218

Iso turning
Hide thumbs Also See for Sinumerik 802D sl:
Table of Contents

Advertisement

Machine and Setting Data
D.2 Channel-specific machine data
22930
SD number
Default setting: 0
Changes effective after POWER ON
Data type: BYTE
Meaning:
24004
MD number
Default setting: 0
Changes effective after POWER ON
Data type: DWORD
Meaning:
This MD cannot SINUMERIK 802D sl.
D-218
EXTERN_PARALLEL_GEOAX
Assignment of parallel channel geometry axis
Minimum input limit: 0
Protection level: 2/7
Assignment of axes parallel to the geometrical axes. Using this table, parallel channel axes
can be assigned to geometrical axes.
Within the ISO dialect mode, the parallel axes can then be activated as geometrical axes
by commanding a G code for plane selection (G17 - - G19) together with the axis designa-
tion of the relevant parallel axis. Axis interchange is then carried out with the axis defined in
$MC_AXCONF_GEOAX_ASSIGN_TAB[ ].
Prerequisite: The channel axes in use must be active.
Entering a zero deactivates the relevant parallel geometrical axis.
CHBFRAME_POWERON_MASK
Delete channel- -specific base frame on Power On
Minimum input limit: 0
Protection level: 2/7
This machine data defines whether channel- -specific base frames are deleted on a Power
On reset, i.e. work shifts and rotations are reset to 0, scaling is set to 1. Mirroring is swit-
ched off. The selection can be made separately for the individual base frames.
Bit 0 corresponds to base frame 0, bit 1 to base frame 1, etc.
0: Base frame is retained on Power On
1: Base frame is deleted on Power On.
SINUMERIK 802D sl/840D sl840D/840Di sl/840Di/810D ISO Turning - - 04.07 Edition
Maximum input limit: 3
Unit: - -
Applies with effect from SW version: 6.2
Maximum input limit: 0xFF
Unit: - -
Applies with effect from SW version: 5.2
© SIEMENS AG 2007 All rights reserved
04.07

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents