Siemens Sinumerik 802D sl Programming Manual page 213

04.07
20150
MD Number
Default setting: 2, 0, 0, 1, 0, ...
Changes effective after RESET
Data type: BYTE
Bedeutung:
20154
MD number
Default setting: - -
Changes effective after Power On
Data type: BYTE
Meaning:
This MD cannot SINUMERIK 802D sl.
© SIEMENS AG 2007 All rights reserved
SINUMERIK 802D sl/840D sl840D/840Di sl/840Di/810D ISO Turning - - 04.07 Edition
GCODE_RESET_VALUES
Initial setting of G groups
Minimum input limit: - -
Protection level: 2/7
Definition of G codes which become active on runup and reset or at part program end.
The index of the G codes in the respective groups must be programmed as the default
value.
Title Group
GCODE_RESET_VALUES[0]
GCODE_RESET_VALUES[1]
GCODE_RESET_VALUES[2]
GCODE_RESET_VALUES[3]
GCODE_RESET_VALUES[4]
GCODE_RESET_VALUES[5]
GCODE_RESET_VALUES[6]
GCODE_RESET_VALUES[7]
GCODE_RESET_VALUES[8]
GCODE_RESET_VALUES[9]
GCODE_RESET_VALUES[10]
GCODE_RESET_VALUES[11]
GCODE_RESET_VALUES[12]
GCODE_RESET_VALUES[13]
GCODE_RESET_VALUES[14]
GCODE_RESET_VALUES[15]
...
EXTERN_GCODE_RESET_VALUES[n]: 0, ..., 30
Defines the G codes which are activated on startup if the NC channel is not running in
Siemens mode.
Minimum input limit: - -
Protection level: 2/2
The following external programming languages are possible:
- - ISO dialect milling
- - ISO dialect turning
The G group classification to be used is specified in the current SINUMERIK documenta- -
tion.
The following groups can be defined within MD EXTERN_GCODE_RESET_VALUES:
ISO dialect M: G code group 2:
G code group 3:
G code group 5:
G code group 6:
G code group 13:
G code group 14:
ISO dialect T: G code group 2:
G code group 3:
G code group 5:
G code group 6:
G code group 16:
Machine and Setting Data
D.2 Channel-specific machine data
Maximum input limit: - -
Unit: - -
Applies with effect from SW version:
Default
1 2 (G01)
2 0 (inaktiv)
3 0 (inaktiv)
4 1 (START FIFO)
5 0 (inaktiv)
6 1 (G17) bei Fräsen
7 1 (G40)
8 1 (G500)
9 0 (inaktiv)
10 1 (G60)
11 0 (inaktiv)
12 1 (G601)
13 2 (G71)
14 1 (G90)
15 2 (G94)
16 1 (CFC)
Maximum input - -
Unit: - -
Applies with effect from SW version: 5
G17/G18/G19
G90/G91
G94/G95
G20/G21
G96/G97
G54- -G59
G96/G97
G90/G91
G94/G95
G20/G21
G17/G18/G19
D-213