Agilent Technologies X Series Programmer's Manual page 55

SCPI Status Bits/OPC
Dependencies
Questionable Calibration Extended Needed Event Query This query returns the decimal
value of the sum of the bits in the Questionable Calibration Extended Needed Event
register.
The register requires that the associated PTR or NTR filters be set
NOTE
before a condition register bit can set a bit in the event register. The
data in this register is latched until it is queried. Once queried, the
register is cleared.
Mode All
Remote
:STATus:QUEStionable:CALibration:EXTended:NEEDed[:EVENt]?
Command
Example STAT:QUES:CAL:EXT:NEED?
Preset 0
SCPI Status Sequential command
Bits/OPC
Dependencies
Questionable Calibration Extended Needed Negative Transition This command determines
which bits in the Questionable Calibration Extended Needed Condition register will set
the corresponding bit in the Questionable Calibration Extended Needed Event register
when the condition register bit has a negative transition (1 to 0). The variable <integer> is
the sum of the decimal values of the bits that you want to enable.
Mode
Remote
Command
Example
Preset
Min
Max
SCPI Status
Bits/OPC
Dependencies
Questionable Calibration Extended Needed Positive Transition This command determines
which bits in the Questionable Calibration Extended Needed Condition register will set
Chapter 1
Sequential command
All
:STATus:QUEStionable:CALibration:EXTended:NEEDed:NTRansition
<integer>
:STATus:QUEStionable:CALibration:EXTended:NEEDed:NTRansition?
STAT:QUES:CAL:EXT:NEED:NTR 2 Align EMI conducted is not required.
0
0
32767
Sequential command
Introduction to Programming X-Series Applications
STATus Subsystem (Remote Only Commands)
55