Agilent Technologies X Series Programmer's Manual page 12

Introduction to Programming X-Series Applications
Using Embedded Help for Programming
List of Commands
The List of Commands is an alphabetically sorted list of all commands in the current
measurement application. Each listing shown is a link to the specific Help Topic that
contains the command or query. See a partial example of a List of Commands in
on page 12.
Figure 1-3 Example List of Commands
You can query the analyzer for all supported SCPI commands in the
NOTE
current mode by sending the "SYST:HELP:HEAD?" query. For details on
how to query the instrument see
on page
12
13.
"Communicating SCPI Using Telnet"
Figure 1-3
Chapter 1