Agilent Technologies X Series Programmer's Manual page 98

Measurement Synchronization with LXI-B
Setting Up and Executing a List Sweep Measurement
16. Enable the MXG's
LXI Output LAN Event
17. Disable LXI Output
LAN Events on the
MXA
18. Put the MXA into
SA mode
19. Put the MXA into
single sweep mode.
20. Choose the MXA's
PTP domain
21. Choose the MXA's
LXI domain
22. Move the MXA into
the list sweep
measurement
23. Send the MXA a list
of frequencies.
24. Configure the
MXA's list sweep
parameters.
25. Make sure the
MXA's LXI LAN
triggers are disabled
98
:LXI:EVENt:OUTPut:LAN:ENABled
"LAN0",1
:LXI:EVENt:OUTPut:LAN:DISable:ALL
:INST:SEL:SA
:INIT:CONT OFF
:LXI:CLOCk:PTP:DOMain 0
:LXI:EVENt:DOMain 0
CONF:LIST
LIST:FREQ 100 MHz, 200 MHz, 300
MHz, 400 MHz, 500 MHz
LIST:ATT 10dB
LIST:BAND:RES:TYPE FLAT
LIST:BAND:RES 300 kHz
LIST:BAND:VID 3MHz
LIST:SWE:TIME 1e-6 s
LIST:TRIG:DEL 0
LIST:DET RMS
:TRIG:LXI:LAN:DISable:ALL
This command is sent
to the MXG.
This command is sent
to the MXA
This command is sent
to the MXA.
This command is sent
to the MXA.
This command is sent
to the MXA.
The parameter value
should match the one
used in Task 3.
This command is sent
to the MXA.
The parameter value
should match the one
used in Task 4.
This command is sent
to the MXA.
This command is sent
to the MXA.
Measurements will be
taken at each of these
frequencies.
These commands are
sent to the MXA.
This command is sent
to the MXA.
Chapter 3