Agilent Technologies X Series Programmer's Manual page 50

Introduction to Programming X-Series Applications
STATus Subsystem (Remote Only Commands)
Remote Command
Example
Preset
SCPI Status Bits/OPC
Dependencies
Questionable Calibration Skipped Enable This command determines which bits in the
Questionable Calibration Skipped Condition Register will set bits in the Questionable
Calibration Skipped Event register, which also sets bit 11 of the Questionable Calibration
Register. The variable <integer> is the sum of the decimal values of the bits you want to
enable.
Mode
Remote Command
Example
Preset
Min
Max
SCPI Status Bits/OPC
Dependencies
Questionable Calibration Skipped Event Query This query returns the decimal value of the
sum of the bits in the Questionable Calibration Event register.
The register requires that the associated PTR or NTR filters be set
NOTE
before a condition register bit can set a bit in the event register. The
data in this register is latched until it is queried. Once queried, the
register is cleared.
Mode
Remote Command
Example
Preset
SCPI Status Bits/OPC
Dependencies
50
:STATus:QUEStionable:CALibration:SKIPped:CONDition?
STAT:QUES:CAL:SKIP:COND?
0
Sequential command
All
:STATus:QUEStionable:CALibration:SKIPped:ENABle
<integer>
:STATus:QUEStionable:CALibration:SKIPped:ENABle?
STAT:QUES:CAL:SKIP:ENAB 1 Can be used to query if an
EMI alignment skipped condition is detected
32767
0
32767
Sequential command
All
:STATus:QUEStionable:CALibration:SKIPped[:EVENt]?
STAT:QUES:CAL:SKIP?
0
Sequential command
Chapter 1