Agilent Technologies X Series Programmer's Manual page 54

Introduction to Programming X-Series Applications
STATus Subsystem (Remote Only Commands)
Preset 32767
Min 0
Max 32767
SCPI Status Sequential command
Bits/OPC
Dependencies
Questionable Calibration Extended Needed Register
Questionable Calibration Extended Needed Condition This query returns the decimal value
of the sum of the bits in the Questionable Calibration Extended Needed Condition register.
The data in this register is continuously updated and reflects the
NOTE
current conditions.
Mode All
Remote
:STATus:QUEStionable:CALibration:EXTended:NEEDed:CONDition?
Command
Example STAT:QUES:CAL:EXT:NEED:COND?
Preset 0
SCPI Status Sequential command
Bits/OPC
Dependencie
s
Questionable Calibration Extended Needed Enable This command determines which bits in
the Questionable Calibration Extended Needed Condition Register will set bits in the
Questionable Calibration Extended Needed Event register, which also sets bit 14 of the
Questionable Calibration Register. The variable <integer> is the sum of the decimal values
of the bits you want to enable.
Mode
Remote Command
Example
Preset
Min
Max
54
All
:STATus:QUEStionable:CALibration:EXTended:NEEDed:ENABle
<integer>
:STATus:QUEStionable:CALibration:EXTended:NEEDed:ENABle?
STAT:QUES:CAL:EXT:NEED:ENAB 2 Can be used to query if an
EMI conducted alignment is needed.
32767
0
32767
Chapter 1