Agilent Technologies X Series Programmer's Manual page 77

of commands indicated below:
[:SENSe]
:TRIGger
[:SENSe]
Bad Command
PWR:ATT 40dB
The short form of POWER is POW, not PWR.
FREQ:STAR 30MHz;MIX:RANG -20dBm
The MIX:RANG command is in the same :SENSE subsystem as FREQ, but executing the FREQ
command puts you back at the SENSE level. You must specify POW to get to the MIX:RANG
command.
FREQ:STAR 30MHz;POW:MIX RANG -20dBm
MIX and RANG require a colon to separate them.
:POW:ATT 40dB;TRIG:FREQ:STAR 2.3GHz
:FREQ:STAR is in the :SENSE subsystem, not the :TRIGGER subsystem.
:POW:ATT?:FREQ:STAR?
:POW and FREQ are within the same :SENSE subsystem, but they are two separate commands, so
they should be separated with a semicolon, not a colon.
:POW:ATT -5dB;:FREQ:STAR 10MHz
Attenuation cannot be a negative value.
Chapter 2
:POWer
[:RF]
:ATTenuation 40dB
[:SEQuence]
:EXTernal [1]
:SLOPe
POSitive
:FREQuency
:STARt
:POWer
[:RF]
:MIXer
:RANGe
[:UPPer]
Good Command
POW:ATT 40dB
FREQ:STAR 30MHz;POW:MIX:RANG -20dBm
FREQ:STAR 30MHz;POW:MIX:RANG -20dBm
:POW:ATT 40dB;:FREQ:STAR 2.3GHz
:POW:ATT?;:FREQ:STAR?
:POW:ATT 5dB;:FREQ:STAR 10MHz
Programming Fundamentals
SCPI Language Basics
77