4. Choose the MXG's
LXI domain
5. Preset the MXG's list
sweep
6. Tell the MXG to
expect a list of
frequencies
7. Tell the MXG to
expect a list of powers.
8. Tell the MXG how
the lists will be entered.
9. Send the MXG a list
of frequencies
10. Send the MXG a list
of powers
11. Turn off signal
modulation.
12. Turn signal output
on.
13. Set the MXG's
trigger source.
14. Reset the MXA
Chapter 3
:LXI:EVENt:DOMain 0
:LIST:TYPE:LIST:INIT:PRES
:FREQ:MODE LIST
:POW:MODE LIST
:LIST:TYPE LIST
:LIST:FREQ 100 MHz, 200 MHz, 300
MHz, 400 MHz, 500 MHz
:LIST:POW 0 dBm, -1 dBm, -2 dBm, -3
dBm, -4 dBm
:OUTP:MOD OFF
:OUTP ON
LIST:TRIG:SOUR ALARM
*RST
Measurement Synchronization with LXI-B
Setting Up and Executing a List Sweep Measurement
This command is sent
to the MXG.
The parameter may
be any integer 0-255.
This command is sent
to the MXG
This command is sent
to the MXG.
This command is sent
to the MXG.
An arbitrary list will
be used instead of
range and step size
arguments.
This command is sent
to the MXG.
The MXG will put out
signals at these
frequencies and in
this order.
This command is sent
to the MXG.
The MXG will put out
signals at these
powers and in this
order.
This command is sent
to the MXG.
This command is sent
to the MXG.
This command is sent
to the MXG.
This command is sent
to the MXA.
101