Agilent Technologies X Series Programmer's Manual page 56

Introduction to Programming X-Series Applications
STATus Subsystem (Remote Only Commands)
the corresponding bit in the Questionable Calibration Extended Needed Event register
when the condition register bit has a positive transition (0 to 1). The variable <integer> is
the sum of the decimal values of the bits that you want to enable.
Mode
Remote
Command
Example
Preset
Min
Max
SCPI Status
Bits/OPC
Dependencies
Questionable Frequency Register
Questionable Frequency Condition This query returns the decimal value of the sum of the
bits in the Questionable Frequency Condition register.
The data in this register is continuously updated and reflects the
NOTE
current conditions.
Mode
Remote Command
Example
Preset
SCPI Status Bits/OPC
Dependencies
Questionable Frequency Enable This command determines which bits in the Questionable
Frequency Condition Register will set bits in the Questionable Frequency Event register,
which also sets the Frequency Summary bit (bit 5) in the Questionable Register. The
variable <integer> is the sum of the decimal values of the bits you want to enable.
Mode
Remote Command
56
All
:STATus:QUEStionable:CALibration:EXTended:NEEDed:PTRansition
<integer>
:STATus:QUEStionable:CALibration:EXTended:NEEDed:PTRansition?
STAT:QUES:CAL:EXT:NEED:PTR 2 Align EMI conducted is required.
32767
0
32767
Sequential command
All
:STATus:QUEStionable:FREQuency:CONDition?
STAT:QUES:FREQ:COND?
0
Sequential command
All
:STATus:QUEStionable:FREQuency:ENABle
:STATus:QUEStionable:FREQuency:ENABle?
<integer>
Chapter 1