Agilent Technologies X Series Programmer's Manual page 52

Introduction to Programming X-Series Applications
STATus Subsystem (Remote Only Commands)
The data in this register is continuously updated and reflects the
NOTE
current conditions.
Mode All
Remote
:STATus:QUEStionable:CALibration:EXTended:FAILure:CONDition?
Command
Example STAT:QUES:CAL:EXT:FAIL:COND?
Preset 0
SCPI Sequential command
Status
Bits/OPC
Dependenci
es
Questionable Calibration Extended Failure Enable This command determines which bits in
the Questionable Calibration Extended Failure Condition Register will set bits in the
Questionable Calibration Extended Failure Event register, which also sets bit 9 of the
Questionable Calibration Register. The variable <integer> is the sum of the decimal values
of the bits you want to enable.
Mode
Remote Command
Example
Preset
Min
Max
SCPI Status Bits/OPC
Dependencies
Questionable Calibration Extended Failure Event Query This query returns the decimal
value of the sum of the bits in the Questionable Calibration Extended Failure Event
register.
The register requires that the associated PTR or NTR filters be set
NOTE
before a condition register bit can set a bit in the event register. The
data in this register is latched until it is queried. Once queried, the
52
All
:STATus:QUEStionable:CALibration:EXTended:FAILure:ENABle
<integer>
:STATus:QUEStionable:CALibration:EXTended:FAILure:ENABle?
STAT:QUES:CAL:EXT:FAIL:ENAB 1 Can be used to query if an EMI
conducted alignment is needed.
32767
0
32767
Sequential command
Chapter 1