Power Menu - RED RANGER MONSTRO 8K VV Operation Manual

RED RANGER OPERATION GUIDE

POWER MENU

The Power menu displays the power status of all attached power sources and allows you to turn off the camera.
To access the Power Menu, go to Menu > Power.
POWER IN
The power status displays for all attached power devices. The menu displays the voltage of the source or the relative
percentage of the power left, as well as the time left, if applicable.
LOW VOLTAGE WARNING
When the Low Voltage Warning is enabled and the incoming voltage is less than the level you select, the camera
shows a warning message and the Power Status indicator in the Lower Status Row turns red. This warning gives you
the opportunity to change the battery or prepare for the camera to lose power. The warning continues to show until the
incoming voltage is equal to or higher than the level you select.
RED does not recommend a specific voltage threshold, since that depends on the power draw of the attached
accessories.
To enable the Low Voltage warning, follow the instructions below:
1. Go to Menu > Power.
2. Select the Low Voltage Warning check box.
3. Select the voltage level threshold. The camera warns you when the incoming voltage is less than this level.
POWER OUT
The Power Out menu shows the status of the power out ports on the camera. The statuses are:
N/A: The device is not present.
OK: The power out port is functional.
FAULT: A short or overcurrent tripped the electronic fuse. Remove the device that is connected to the port, as it
may be drawing too much power. Select RESET to clear the fault.
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC 9 5 5 - 0 1 8 4 _V 7 .2 , R EV - D | 8 4