Mix; Audio Output Options; Audio Meter (Vu Meter) - RED RANGER MONSTRO 8K VV Operation Manual

RED RANGER OPERATION GUIDE
PRE-AMP GAIN
Pre-amp gain range is 0 dB to 55 dB. Default is 0 dB.
To adjust amplification levels, follow the instructions below:
1. Go to Menu > Settings > Audio > Control > Pre-Amp Gain.
2. Move the Pre-Amp (pre-amplifier) sliders up and down to adjust the amplification levels.
3. To link the amplification for each channel, select Link.
HEADPHONE VOLUME
Headphone volume range is –54 dB to 0 dB. Default is 0 dB.
CHANGE HEADPHONE VOLUME
1. Go to Menu > Settings > Audio > Control > Headphone Volume.
2. Move the Left and Right sliders up and down to adjust the volume.
3. To toggle mute/unmute, select Mute.
4. To link the volume for Left and Right, select Link.

MIX

The camera features a digital audio mixer that controls the volume and stereo settings for each input channel. The
mixer affects audio monitoring (such as headphones) and audio recorded to external devices. The mixer DOES NOT
affect audio embedded in the R3D file. To access mix settings, go to Menu > Settings > Audio > Mix.
The range for each channel is 0% to 100%. The default for each active channel is 100%.
The digital mixer normalizes each output to prevent the output from exceeding the signal range. For example, if you
pass Channel 1 to an output at 100%, and then mix Channel 2 into the same output, the level of Channel 1 decreases
to 50%.
Assign each audio channel to the Left, Middle, or Right side of the stereo mix. Move the sliders up and down to
adjust the volume.
You can control the volume and stereo for each audio monitoring option:
Headphone Mix: Headphones plugged into the camera.
Monitor Mix: External HD-SDI monitors that support audio.

AUDIO OUTPUT OPTIONS

One (1) 2-channel headphone output. For maximum quality, use high impedance headphones.
HD-SDI monitor: Output two (2) channels of 24-bit 48 kHz uncompressed, embedded digital audio. Select and mix
the stereo channels in the Monitor Mix menu at Menu > Settings > Audio > Mix > Monitor Mix. To monitor or HD-
SDI, the third-party monitor must support audio.

AUDIO METER (VU METER)

The Audio Meter displays at the bottom-right corner of the viewfinder, and displays either the incoming audio channels
(default), or the outgoing audio (mixes). For more information, go to
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC
"VU Meter" on page 80.
9 5 5 - 0 1 8 4 _V 7 .2 , R EV - D | 1 4 5