RED RANGER MONSTRO 8K VV Operation Manual page 107

RED RANGER OPERATION GUIDE
REDCODE BURST
NOTE: This mode is not available in Stills mode.
NOTE: Audio is not recorded in REDCODE Burst mode.
In REDCODE Burst mode, the camera can record at a lower compression (REDCODE) for the specified amount of
frames. When REDCODE Burst mode is enabled and recording starts, the camera captures a "burst" of frames at the
lower REDCODE, and then continues to record at the next available REDCODE. To add more bursts to clips during
recording, press any key mapped to "Record: Mark Frame".
To use REDCODE Burst mode, follow the instructions below:
1. Go to Menu > Settings > Recording > Mode.
2. Select REDCODE Burst from the Mode drop-down menu.
3. Use the Limit Recording to fields to set the recording to end at a predefined frame limit (optional).
4. Select a Pre Count and Post Count. For more information, go to
5. Close the menu.
6. Start recording.
Figure: REDCODE Burst
PRE COUNT AND POST COUNT
When Frame Trigger or Burst mode is enabled, select the number of frames for the Pre Count and Post Count:
Pre Count: The camera captures the frame cache from the time preceding the marker.
Post Count: The camera captures the remaining frame cache after the marker.
The maximum frame counts are listed in the Available column, and are based on format and REDCODE.
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC
"Pre Count and Post Count"
9 5 5 - 0 1 8 4 _V 7 .2 , R EV - D | 1 0 7
below.