RED RANGER MONSTRO 8K VV Operation Manual page 167

RED RANGER OPERATION GUIDE
GENERAL: LENS MOUNT NOT FUNCTIONING
SYMPTOM
The lens mount is not functioning correctly, or is not communicating with the camera.
POTENTIAL RESOLUTIONS
Perform a Hardware Rediscover. For more information, go to
Upgrade your camera firmware. For more information, go to
Reset your camera's default settings. For more information, go to
CAMERA DOES NOT RECOGNIZE LENS
SYMPTOM
The camera does not recognize the attached lens.
POTENTIAL RESOLUTIONS
Ensure that the lens is compatible. For more information, go to
If using a PL lens, ensure that the camera is providing power to the lens: go to Menu > Settings > Setup > Lens
and select the Enable Power to Lens check box.
Detect the lens: go to Menu > Settings > Setup > Lens and select Detect Lens.
Perform a Hardware Rediscover. For more information, go to
CAMERA DISPLAYS N/A FOR APERTURE
SYMPTOM
The camera displays N/A for aperture when a lens is attached.
POTENTIAL RESOLUTIONS
Ensure that your lens is completely locked in place.
Remove your lens mount. Check the connection points for damage or debris. Install your lens mount.
Perform a Hardware Rediscover. For more information, go to
Re-install your camera firmware.
If your camera is on beta firmware, downgrade to the release build.
If you are using a DSMC PL mount, go to Menu > Settings > Setup > Lens and ensure that power is enabled.
NOTE: Some lenses do not display the aperture information because they are incompatible. Some PL lenses do not
have i-technology data.
CANNOT SEE MENUS ON LCD TOUCHSCREEN
SYMPTOM
The LCD touchscreen does not display menus.
POTENTIAL RESOLUTION
Double-tap the LCD touchscreen to exit Clean mode.
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC
"Rediscover (Hardware Rediscover)" on
"Upgrade Camera Firmware" on
"Reset Defaults" on
"Lenses" on page 208.
"Rediscover (Hardware Rediscover)" on
"Rediscover (Hardware Rediscover)" on
page 135.
page 161.
page 135.
page 135.
page 135.
9 5 5 - 0 1 8 4 _V 7 .2 , R EV - D | 1 6 7