Communication Ports - RED RANGER MONSTRO 8K VV Operation Manual

RED RANGER OPERATION GUIDE

COMMUNICATION PORTS

CTRL (RS232 CONTROL)
The 4- Pin 00B CTRL Connector supports RS232 remote control for 3D camera communication and third- party
metadata ingest applications. For more information, go to
The General Purpose Out (GPO) tally presents 3.3 V at a maximum of 0.04 A between pins 1 and 3. When used as a
record tally, the rising edge of the pulse indicates start of record, falling edge represents end of record.
For more information about controlling the camera via RS232, download the
www.red.com/developers.
Figure: Front Face of the CTRL (RS232) Connector (Looking at the Camera)
PIN SIGNAL
1 GROUND
2 232 RX
3 SS/GPO
4 232 TX
NOTE: Mating connector is FGG.00.304.CLAD.
COMPATIBLE CABLES
790-0154, 790-0643: 3BNC-to-00 Sync Cable
790-0187, 790-0648: 4-Pin 00B-to-Flying Lead
790-0415: RED Start/Stop Cable (14-Pin 1B to SYNC, CTRL, BNC)
GENLOCK
The 75 ohm BNC connector accepts incoming sync and genlock signals.
PIN
Center
Shield/Screen
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC
4-PIN 00B CTRL CONNECTOR
DESCRIPTION
Common ground
RS232 RX
Shutter sync/general purpose output
RS232 TX
75 OHM BNC CONNECTOR
SIGNAL DESCRIPTION
SYNC SMPTE ST 274
RS 170A Tri-Level Sync
GROUND Camera ground
"BRAIN GPIO" on page 129.
R.C.P.™ SDK , available at
DIRECTION
N/A
In
Out
Out
DIRECTION
In
N/A
9 5 5 - 0 1 8 4 _V 7 .2 , R EV - D | 1 9 7