Set Up Stereo/3D Configuration - RED RANGER MONSTRO 8K VV Operation Manual

RED RANGER OPERATION GUIDE

SET UP STEREO/3D CONFIGURATION

This section describes basic procedures for connecting two (2) cameras in a Master/Slave configuration for 3D
operation.
NOTE: When providing the signals to a Stereo Image Processor (SiP) for verifying 3D alignment, set the HD-SDI
monitor output on both cameras to have the same overlay configuration.
NOTE: For genlock to function correctly, the cameras must be on the same firmware version, and must be using the
same project time base and recording frame rate.
To set up a Stereo/3D setup, follow the instructions below.
1. On both cameras, set the project time base and recording frame rate.
2. On both cameras, follow the instructions in
The GEN and SYNC indicators in the Lower Status Row illuminate green.
3. Follow the instructions in
4. On both cameras, follow the instructions in
set up media and camera settings.
REQUIRED CABLES
Use one (1) per camera:
75 ohm BNC cable (such as the RED HD-SDI Cable, P/N 790-0341)
Use one (1) per setup:
790-0163: Master/Slave Gig-E Cable (4')
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC
"Sensor Sync" on page 152
"Set Up Master/Slave Operation" on page 154
"Set Reel Number, Camera ID, and Camera Position" on page 156
to achieve Sensor Sync genlock status.
to set Master and Slave camera settings.
9 5 5 - 0 1 8 4 _V 7 .2 , R EV - D | 1 5 8
to