Control - RED RANGER MONSTRO 8K VV Operation Manual

RED RANGER OPERATION GUIDE

CONTROL

To adjust the input, pre-amplifier, and headphone settings, select Control.
CHANNEL 1/2 AND CHANNEL 3/4
To set up Channel 1/2 and 3/4, go to Menu > Settings > Audio > Control.
Figure: Channel Setup
SOURCE
SOURCE NAME
None
Camera Internal
Rear Analog
NAME
You can rename each audio channel. The default names are Ch1, Ch2, Ch3, and Ch4. The channel names display in
the Audio Meter, but are not included in the clip metadata.
MODE
When Rear Analog is selected, the Mode (Line, Mic, or +48V) displays for the incoming audio signal.
PHANTOM POWER
The 5-pin XLR connector provides +48 V phantom phantom power.
Enable phantom power (via the switch adjacent to the XLR port) after a microphone is connected. Disable phantom
power (by switching to Line or Mic) before removing the microphone.
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC
CHANNEL PAIRS
N/A
Ch1/Ch2, Ch3/Ch4
Ch1/Ch2, Ch3/Ch4
CONNECTORS
N/A
Mic 1, Mic 2
AUDIO (full-size XLR)
9 5 5 - 0 1 8 4 _V 7 .2 , R EV - D | 1 4 4