Record/Monitor Out Ports - RED RANGER MONSTRO 8K VV Operation Manual

RED RANGER OPERATION GUIDE

RECORD/MONITOR OUT PORTS

3G-SDI (HD-SDI) OUT
SDI-1 and SDI-2 output a cloned 3G-SDI signal.
A standard 75 ohm BNC connector provides the following output:
Legal range of HD-SDI signals
Broadcast specification 3G-SDI (HD-SDI) video output (default mode is Clean)
Two (2) channels of embedded audio
Time of Day and Edge timecode
Record Tally flag
Clip name information (as SMPTE RP-188 VITC2 HANC metadata)
The 3G-SDI (HD-SDI) output provides the formats described in the table below:
2
VIDEO FEED FREQUENCY (HZ)
720p 23.98, 24.00, 25.00, 29.97, 30.00, 50.00, 59.94
1080p 10-bit 4:2:2 23.98, 24.00, 25.00, 29.97, 30.00
1080p 10-bit 4:2:2 50.00, 59.94, 60.00
1. Ensure that you select a frequency supported by your monitor.
2. The output is progressive scan (p); it does not support progressive segmented frame (PsF) or interlaced (i) scan formats.
3. The frequency options depend on project time base. If you have a non-drop frame project time base (such as 24.00), you can select only non-
drop frame frequencies. If you have a drop frame project time base (such as 23.98), you can select only drop frame frequencies.
PIN
Center
Shield/Screen
COMPATIBLE CABLE
®
790-0341: RED HD-SDI Cable (6')
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC
3G-SDI (HD-SDI) OUTPUT FORMATS
3
75 OHM BNC CONNECTOR
SIGNAL DESCRIPTION
3G-SDI SMPTE ST 424
GROUND Camera ground
1
SMPTE STANDARD
SMPTE ST 292-1 (1.485 Gbps)
SMPTE ST 292 (1.485 Gbps)
3G-SDI
SMPTE ST 424 (2.970 Gbps)
SMPTE ST 425 (2.970 Gbps)
DIRECTION
Out
N/A
9 5 5 - 0 1 8 4 _V 7 .2 , R EV - D | 1 9 5