RED RANGER MONSTRO 8K VV Operation Manual page 73

RED RANGER OPERATION GUIDE
LOOK AROUND
To enable Look Around, go to Menu > Monitoring > Look Around.
When Look Around is enabled, the Frame Guide and recording area are scaled down on the display so that you can
see what images will enter the recording area.
To assign a Shading overlay to the Look Around area (the area outside of the recording area), go to
page 81.
Look Around limits the available frame rates. At high resolutions, the recording area on the display shows the full
sensor area or full sensor height, so there is no extra room for Look Around.
Look Around may affect the recorded file:
R3D: Only the area inside the frame is recorded; the Look Around area is NOT recorded.
Apple ProRes: The full image is recorded, including the Look Around area.
Avid DNxHD/HR: The full image is recorded, including the Look Around area.
ADVANCED
Provides access to additional monitor settings.
VIDEO
SMALL DIALOGS ON 9" LCD
The dialogs on the RED Touch 9.0" LCD are smaller than the default dialogs.
ALLOW REDUCED JUDDER PREVIEW
Reduced Judder Preview allows the camera to preview images at a refresh rate that is twice the project time base. For
example, if the project time base is 23.98 FPS or 24.00 FPS, enabling Reduced Judder Preview causes the LCD or
EVF to have a refresh rate of 48 Hz (50 Hz).
You cannot use Reduced Judder Preview when:
Varispeed is enabled.
Speed Ramp mode is enabled.
Genlock is enabled.
The shutter angle is 180° or greater.
NOTE: When you disable Reduced Judder Preview mode, the image on the EVF may be disrupted for up to three (3)
seconds.
GLOBAL FLIP/MIRROR
Applies Flip/Mirror to all monitors. For more information, go to
DISABLE LCD TEMPERATURE WARNINGS
Disables the "cooling advised" messages for the DSMC2 Touch 7.0" Ultra-Brite LCD. For more information, go to
"Cooling Advised Messages" on
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC
page 177.
"Flip/Mirror" on the previous
"General Tab" on
page.
9 5 5 - 0 1 8 4 _V 7 .2 , R EV - D | 7 3