RED RANGER MONSTRO 8K VV Operation Manual page 150

RED RANGER OPERATION GUIDE
SET UP INTERNAL TIMECODE
To set up and adjust timecode generated by the camera, follow the instructions below:
1. Go to Menu > Settings > Project > Timecode.
2. Select the desired Timecode Display mode.
3. Set Source to RTC.
The TC indicator in the Lower Status Row remains grey when internal timecode is enabled.
Figure: Timecode
INPUT EXTERNAL TIMECODE
To input timecode generated by an external device, follow the instructions below:
1. Connect the TIMECODE port on the camera to the device using a 75 ohm BNC cable.
2. Go to Menu > Settings > Project > Timecode.
3. Select the desired Timecode Display Mode.
4. Set Source to External.
The TC indicator in the Lower Status Row turns green when an external timecode source is locked.
NOTE: When an external source is selected but not present, timecode displays User Provided settings.
REQUIRED CABLE
790-0212: PRO I/O TIMECODE CABLE (3')
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC 9 5 5 - 0 1 8 4 _V 7 .2 , R EV - D | 1 5 0