RED RANGER MONSTRO 8K VV Operation Manual page 109

RED RANGER OPERATION GUIDE
ENABLE MULTI-SHOT MODE
To enable Multi-Shot mode, follow the instructions below:
1. Set the camera to Stills mode. For more information, go to
2. Go to Menu > Settings > Recording > Mode.
3. Select Multi-Shot from the Mode drop-down menu.
4. Use the Limit Recording to fields to set the recording to end at a predefined frame limit (optional).
5. Close the menu.
MOTION + STILLS
NOTE: This mode is available in Motion mode, but is only recommended in Stills mode.
Motion + Stills mode is identical to Continuous Record, except that when you initiate recording by pressing the
PWR/REC key on the camera, all other Record keys mark frames for the duration of the clip. (If you initiate recording
by pressing any other Record key, you can press any key mapped to "Record: Mark Frame" to mark stills.)
To use Motion + Stills mode, follow the instructions below:
1. Set the camera to Stills mode. For more information, go to
2. Go to Menu > Settings > Recording > Mode.
3. Select Motion + Stills from the Mode drop-down menu.
4. Use the Limit Recording to fields to set the recording to end at a predefined frame limit (optional).
5. Close the menu.
6. Press the PWR/REC key on the camera to start recording.
7. Press the Record key on the media bay to mark a frame.
8. Press the PWR/REC key on the camera to stop recording.
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC
"Camera Mode" on page 51.
"Camera Mode" on page 51.
9 5 5 - 0 1 8 4 _V 7 .2 , R EV - D | 1 0 9