Record - RED RANGER MONSTRO 8K VV Operation Manual

RED RANGER OPERATION GUIDE

RECORD

Perform one of the following actions to begin recording:
Press PWR/REC on the camera.
Press START/STOP on the DSMC2 Top Handle or DSMC2 Outrigger Handle.
Trigger start/stop with a compatible third-party trigger.
Double-tap the right 25% on an attached touchscreen display (when enabled).
NOTE: To enable Double-Tap Right 25% to Record, go
RECORD VIA HD-SDI
NOTE: Audio is not embedded in the MON-1 signal.
This section describes how to record via HD-SDI through simultaneous record (recording to an SSD and an external
recorder at the same time) or external record only.
SIMULTANEOUS RECORD
NOTE: The secondary LCD/EVF port and a MON- 1 port cannot be used at the same time. Go to
Preferences" on page 70.
You can record simultaneously to an external recorder and a RED SSD. To record simultaneously, follow the
instructions below:
1. Connect the camera to an external recorder with an HD-SDI cable.
2. Ensure that a formatted SSD is inserted in the camera.
3. Set up the HD-SDI output:
A. Go to Menu > Monitoring > Monitors and select a monitor.
B. Select Clean from the Mode drop-down menu (otherwise the external recorder records the overlay).
C. Select the output resolution from the Resolution drop-down menu.
NOTE: The HD-SDI maximum resolution is 1080p. For more information, go to
page 195.
4. Disable all False Colors (otherwise the external recorder records the False Colors). For more information, go to
"Tools" on page 75.
5. If monitoring audio via a third-party monitor that supports audio, set up the monitor mix:
A. Go to Menu > Settings > Audio > Mix > Monitor Mix.
B. Adjust the input channels.
6. Go to Menu > Settings > Recording > Mode.
7. Select Local from the Storage drop-down menu.
8. Begin recording.
C O PYR I G HT © 2 0 1 9 R ED.C O M , LLC
"Advanced" on page 73.
"Monitor
"Record/Monitor Out Ports" on
9 5 5 - 0 1 8 4 _V 7 .2 , R EV - D | 4 3