Monitoring The New Recorded Sound - Sony Handycam DCR-PC101E Operating Instructions Manual

Audio dubbing
5
PAGE1 PAGE2 PAGE3 EXIT PAGE1 PAGE2 PAGE3 EXIT PAGE1 PAGE2 PAGE3 EXIT PAGE1 PAGE2 PAGE3 EXIT PAGE1 PAGE2 PAGE3 EXIT PAGE1 PAGE2 PAGE3 EXIT PAGE1 PAGE2 PAGE3 EXIT PAGE1 PAGE2 PAGE3 EXIT
V SPD DATA DATA DATA DATA DATA DATA DATA A DUB AUDIO AUDIO AUDIO AUDIO AUDIO AUDIO AUDIO
CODE CODE CODE CODE CODE CODE CODE PLAY CTRL DUB DUB DUB DUB DUB DUB DUB
To add new sound more precisely
Press ZERO SET MEMORY at the point where
you want to stop recording later in playback.
Carry out step 3. Recording automatically stops
at the point where ZERO SET MEMORY was
pressed.
Monitoring the new recorded
sound
(1) Play back the tape on which you added audio.
(2) Select AUDIO MIX in
settings, then press EXEC (p. 248).
(3) Press r/R to adjust the balance between the
original sound (ST1) and the new sound
(ST2), then press EXEC.
About five minutes after you disconnect the
power source or remove the battery pack, the
setting of AUDIO MIX returns to the original
sound (ST1) only. The default setting is original
sound only.
A DUB CTRL
REC REC REC REC REC REC REC REC
CTRL CTRL CTRL CTRL CTRL CTRL CTRL CTRL
REC REC REC REC REC REC REC
PAUSE PAUSE PAUSE PAUSE PAUSE PAUSE PAUSE
in the menu
VCR SET
H i F i SOUND
AUD I O M I X
A/VcDV OUT
NTSC PB
r R
RET. RET. RET. RET. RET. RET. RET. RET.
AUDIO REC REC REC REC REC REC REC
START START START START START START DUB START
(1)
(2)
EXIT
ST1 ST2
EXEC RET.
(3)
r R
4
FN
137