Monitoring The New Recorded Sound - Sony DCR-PC115E Operating Instructions Manual

Audio dubbing
Monitoring the new recorded
sound
To play back the sound
Adjust the balance between the original sound
(ST1) and the new sound (ST2) by selecting
AUDIO MIX in in the menu settings (p. 132).
Five minutes after when you disconnect the
power source or remove the battery pack, the
setting of AUDIO MIX returns to the original
sound (ST1) only. The default setting is original
sound only.
Notes
•New sound cannot be recorded on a tape
already recorded in the 16-bit mode (32 kHz,
44.1 kHz or 48 kHz).
•New sound cannot be recorded on a tape
already recorded in the LP mode.
•You cannot add audio with the DV jack.
•You cannot add audio on the blank portion of
the tape.
If an i.LINK cable (DV connecting cable)
(optional) is connected to your camcorder
You cannot add a sound to a recorded tape.
We recommend that you add new sound on a
tape recorded with your camcorder
If you add new sound on a tape recorded with
another camcorder (including other
DCR-PC115E/PC120E), the sound quality may
become worse.
V CR S E T
H i F i SOUND
A UD I O M I X
A / VcD V OU T ST1 ST2
N T S C P B
R E T U R N
[ ME NU ] : E ND
•
•
•
•
121