Maintenance information and
precautions
Adjusting the LCD screen
(CALIBRATION)
The buttons on the touch panel may not work
correctly. If this happens, follow the procedure
below.
(1) Set the POWER switch to OFF (CHARGE).
(2) Eject the tape from your camcorder, then
disconnect any connecting cable from your
camcorder.
(3) Set the POWER switch to VCR while pressing
DISPLAY/TOUCH PANEL on your
camcorder, then keep pressing DISPLAY/
TOUCH PANEL for about five seconds.
(4) Follow the procedure below using an object
such as the corner of a "Memory Stick."
1 Touch
2 Touch
3 Touch
CALIBRATE
Note
If you do not press the right spot,
returns to the position at the upper left corner. In
this case, start from step 4 again.
296
at the upper left corner.
at the lower right corner.
in the middle of the screen.
CALIBRATE
always
(1)
(2)
(3)
(4)
1
2
3
CALIBRATE
END