Monitoring The New Recorded Sound - Sony Handycam DCR-VX2100E Operating Instructions Manual

Audio dubbing
Monitoring the new recorded
sound
To play back the sound
Adjust the balance between the original sound
(ST1) and the new sound (ST2) by selecting
AUDIO MIX in the menu settings (p. 156).
If you wait five minutes after you disconnect
the power source or remove the battery pack,
the setting of AUDIO MIX returns to the
original sound (ST1) only. The default setting
is for original sound only.
Notes
• New sound cannot be recorded on a tape
already recorded in the 16-bit mode (p. 161).
• New sound cannot be recorded on a tape
already recorded in the LP mode.
• You cannot add audio with the
Interface.
If you make all the connections
The audio input to be recorded will take
precedence over others in the following order.
• MIC (PLUG IN POWER) jack
• Intelligent accessory shoe
• AUDIO L/R jacks
• Built-in microphone
If an i.LINK cable (optional) is connected to
your camcorder
You cannot add sound to a recorded tape.
VCR SET
H i F i SOUND
AUD I O M I X
A/V DV OUT ST1
NTSC PB
RETURN
[ MENU ] : END
DV
ST2
141