Table of Contents
Advertisement
Dubbing only desired scenes
– Digital program editing (on tapes)
Step 3: Adjusting the
synchronisation of the VCR
You can adjust the synchronisation of your
camcorder and the VCR.
Prepare a pen and paper for notes.
Before operation, eject a cassette from your
camcorder (if inserted).
(1) Insert a recordable tape into the VCR, then
set the VCR to recording pause.
When you select i.LINK in CONTROL, the
recording pause is not necessary.
(2) Press r/R to select ADJ TEST, then press
EXEC.
(3) Press r/R to select EXECUTE, then press
EXEC.
IN and OUT are recorded on an image for
five times each to calculate the numerical
values for adjusting the synchronisation.
The EXECUTING indicator flashes on the
LCD screen. When finished, the indicator
changes to COMPLETE.
(4) Rewind the tape in the VCR, then start slow
playback.
Take a note of the opening numerical value
of each IN and the closing numerical value
of each OUT.
(5) Calculate the average of five opening
numerical values of five IN, and the average
of all the closing numerical values of each
OUT.
(6) Press r/R to select "CUT-IN", then press
EXEC.
(7) Press r/R to select the average numerical
value of IN, then press EXEC.
The calculated start position for recording is
set.
(8) Press r/R to select "CUT-OUT", then press
EXEC.
(9) Press r/R to select the average numerical
value of OUT, then press EXEC.
The calculated stop position for recording is
set.
(10) Press
RET. to execute.
122
3
(1)
(2)
r R
(3)
r R
(4)
(5)
(6)
r R
(7)
r R
(8)
r R
(9)
r R
(10)
Hide quick links:
Advertisement
Table of Contents
