Sony Handycam DCR-PC101E Operating Instructions Manual page 55

Playing back a tape
Using the Remote Commander
Press the DATA CODE button on the Remote
Commander in playback.
The display changes as follows:
date/time t various settings (SteadyShot OFF,
exposure, white balance, gain, shutter speed,
aperture value) t no indicator
Not to display various settings
Set DATA CODE to DATE in the menu settings
(p. 253).
The display changes as follows when you press
the DATA CODE button on the Remote
Commander: date/time y no indicator
[a]: Tape counter
[b]: SteadyShot OFF
[c]: Exposure mode
[d]: White balance
[e]: Gain
[f]: Shutter speed
[g]: Aperture value
Various settings
Various settings shows the camcorder's
recording information at the time of recording. In
tape recording standby, the various settings will
not be displayed.
When you use the data code function, bars
(-- -- --) appear if:
– A blank portion of the tape is being played
back.
– The tape is unreadable due to tape damage or
noise.
– The tape was recorded by a camcorder without
the date and time set.
Data code
When you connect your camcorder to a TV, the
data code also appears on the TV screen.
Date/time/ Various settings/
40min
0:00:23:01
4 7 2002
12:05:56 F1.8
t
t
y
[a]
40min
0:00:23:01
[b]
[c]
[d]
AUTO
5 0 AWB
[e]
9dB
[f]
[g]
[a]:
[b]:
[c]:
[d]:
[e]:
[f]:
[g]:
55