Monitoring The New Recorded Sound - Sony DCR-TRV38E Service Manual

Audio dubbing

Monitoring the new recorded sound

The POWER switch should be set to
Operate by touching the panel.
(1) Play back the tape on which you added audio.
(2) Press FN to display PAGE1.
(3) Press MENU to display the menu.
(4) Select AUDIO MIX in
(5) Press r/R to adjust the balance between the original sound (ST1) and the new
sound (ST2), then press EXEC.
About five minutes after you disconnect the power source or remove the
battery pack, the setting of AUDIO MIX returns to the original sound (ST1)
only. The default setting is original sound only.
.
, then press EXEC (p. 170).
EXIT
VCR SET
H i F i SOUND
AUD I O M I X
A/VcDV OUT ST1 ST2
r R EXEC RET.
93