Adding An Audio Sound On A Recorded Tape; Monitoring The New Recorded Sound - Sony Handycam DCR-VX2000 Operating Instructions Manual

Audio dubbing

Adding an audio sound on a recorded tape

(1) Insert the recorded tape into your camcorder.
(2) Set the POWER switch to VCR on your camcorder.
(3) Locate the recording start point by pressing N. Then press X at the point
where you want to start recording to set your camcorder to the playback pause
mode.
(4) Press
in the viewfinder.
(5) Press X and start playing back the audio you want to record at the same time.
The new sound is recorded in stereo 2 (ST2) during playback.
(6) Press x at the point where you want to stop recording.

Monitoring the new recorded sound

To play back the sound
Adjust the balance between the original sound (ST1) and the new sound (ST2) by
selecting AUDIO MIX in the menu settings (p. 107).
VCR SET
H i F i SOUND
AUD I O M I X
A/V DV OUT ST1
RETURN
[ MENU ] : END
If you wait five minutes after you disconnect the power source or remove the battery
pack, the setting of AUDIO MIX returns to the original sound (ST1) only. The default
setting is for original sound only.
AUDIO DUB. The green
ST2
X indicator appears on the LCD screen or
POWER switch
AUDIO DUB
95