Sony Handycam DCR-PC101E Operating Instructions Manual page 133

Inserting a scene from a VCR
– Insert editing
4
0:00:00
ZERO SET
ZERO SET
MEMORY MEMORY
5,6
REC CTRL
RET.
FN
REC REC
PAUSE START
To change the insert end point
Press ZERO SET MEMORY again after step 5 to
erase the ZERO SET MEMORY indicator and
begin from step 3.
Note
The picture and sound recorded on the section
between the insert start and end points will be
erased when you insert the new scene.
If you insert scenes on the tape recorded with
other camcorder (including other DCR-PC101E)
The picture and sound may be distorted. We
recommend that you insert scenes on a tape
recorded with your camcorder.
When the inserted picture is played back
The picture and sound may be distorted at the
end of the inserted section. This is not a
malfunction.
The picture and sound at the start point and the
end point may be distorted in the LP mode.
To insert a scene without setting the insert
end point
Skip step 3 and 4. Press x on the Remote
Commander or on your camcorder when
you want to stop inserting.
x
If you press FN
The ZERO SET MEMORY indicator is not
displayed.
133