Selecting A File System - Dentsply Sirona X-Smart Plus User Manual

Step-by-Step Instructions
AUTO REVERSE OFF:
If, during operation the load reaches the preset torque limit value, the
motor handpiece will stop without reverse rotation. The LCD panel
shows "
If you want the file to rotate forward again, press the ON/OFF key twice.
When the motor handpiece starts and its load reaches approximately
half of the preset torque limit value, the alarm sounds (corresponding to
The sound changes when the load approaches the torque limit value
(corresponding to
NOTE
• This function is only available in continuous rotation.
• This function is not activated during reverse rotation.
• When the mark of remaining amount of battery indicates "
the actual power supplied by the motor handpiece load may not
be enough to reach the preset torque limit value. In this case, the
auto reverse function will not be activated. Should high torque be
required, use the AC adapter or use the device when the mark of
the remaining amount of battery indicates "
• If a load is continuously applied to the motor handpiece, it may
automatically stop to prevent overheating. In this case, leave the
motor handpiece for a while until it cools down.
6.7

Selecting a File System

To choose a different file system, press the SYSTEM ▲ or ▼ key. The
file system shown in the display is the selected system.
30/60
" and the rotation speed alternately.
on the bar display).
on the bar display).
BENXSPSDFUWEB / Rev.09 / 10-2018
",
").