Dentsply Sirona X-Smart Plus User Manual page 38

Step-by-Step Instructions
The battery compartment is located at the rear of the unit and its cover
is secured by a screw located on the bottom of the unit.
Turn the power off.
1.
Disconnect the AC adapter.
2.
Remove the screw fixing the cover with a screw driver.
3.
Slide the cover down slightly in the direction of the arrow (toward the
4.
bottom) and remove it.
Take out the battery and pull out the cord, holding it at the connector.
5.
CAUTION
• Ensure that the AC adapter is disconnected before changing the
battery.
• When removing the battery cord, make sure to hold it at the
connector. Failure to do so may damage the cord.
Insert the battery cord connector into the device connector in accordance
with the polarity indication label inside the battery compartment and place
6.
the battery into the compartment with care so as not to catch the cord.
CAUTION
In case of difficulty in inserting the connector, the polarity may be
incorrect. Do not insert it by force.
Close the battery cover.
7.
Tighten the screw with a screwdriver. Do not apply excessive force when
8.
tightening.
Charge the battery before use.
9.
NOTE
The used Nickel Metal Hydride batteries are recyclable, but their
disposal may sometimes not be permitted by law in your location.
Return them to your distributor.
38/60 BENXSPSDFUWEB / Rev.09 / 10-2018