Connecting Encoders - Siemens SIMOTION C230-2 Equipment Manual

Wiring
6.2.3

Connecting encoders

Connecting the connecting cable
Note the following:
Note
Only use shielded cables; the shield must be connected to the metallic or meta-
lized connector housing.
The pre-assembled cable available as an accessory provides the best possible
immunity to interference and adequately dimensioned cross sections for the power
supply to the encoders.
Connecting cable
The following encoders can be connected:
S
Incremental encoder with RS422
S
ROD 320 (built-in encoder in 1FT5)
S
SSI absolute encoder
S
Linear position encoder with EXE
S
SIMODRIVE 611 analog closed-loop control module 1FK6 motors with resolver
S
SIMODRIVE 611 universal with incremental shaft encoder interface
Fig. 6-9
6-94
SIEMENS
C230-2
C230-2
Encoder connections
X7 X3 X4
X1
X2 X5
X6
Axis 1...4
E Siemens AG, 2003 All rights reserved
SIMOTION C230-2, 04.2003 Edition