Siemens SIMOTION C230-2 Equipment Manual page 89

Hide thumbs Also See for SIMOTION C230-2:

Table of Contents

Adjusting power supply to the required mains voltage

Check whether the switch to select the mains voltage is set correctly for your

mains voltage. The basic setting on the PS 307 is always 230 V. Proceed as fol-

lows to change the setting for the mains voltage:

1. Remove the covering cap using a screwdriver.

2. Set the switch for the relevant voltage supply.

3. Refit the covering cap over the switch opening.

Reverse voltage protection

If the connection is correct and the power supply is switched on, the "5 VDC" LED

is illuminated green.

Note

Your module will not work in the case of reverse polarity. However, a built-in re-

verse polarity protection facility will protect the electronics against damage.

Fuse

If a fault is present on the module, a built-in fuse protects the electronics against

consequential damage (e.g. fire). In this case, the module must be replaced.

SIMOTION C230-2, 04.2003 Edition

Wiring

6-89

Table of Contents