After Installation - Siemens SIMOTION C230-2 Equipment Manual

Installation
4.2.3

After installation

Inserting the key
Once the C230-2 has been mounted on the mounting rail, you can insert the key in
the STOP or STOPU position on the C230-2.
STOPU
Fig. 4-7
Assigning the slot numbers
After mounting, you can assign each module a slot number. This eases the assign-
ment of the modules to the configuration table in the Engineering System. Table
4-4 shows the assignment of the slot numbers.
Table 4-4
Slot no.
1
2
3
4
5
6
7
8
9
10
11
4-68
RUN
STOP
Inserting the key in the C230-2
Slot numbers for S7 modules and C230-2
Module
Power supply (PS)
C230-2
Reserved
1. I/O module
2. I/O module
3. I/O module
4. I/O module
5. I/O module
6. I/O module
7. I/O module
8. I/O module
Remark
–
–
–
On the right next to C230-2
–
–
–
–
–
–
–
E Siemens AG, 2003 All rights reserved
SIMOTION C230-2, 04.2003 Edition