Ethernet Remote Control; Gpib Function Of 62000H Series; Introduction To Programming - Chroma 62000H Series Operating & Programming Manual

Here is the connection:
RS485_P
RS485_N
5.1.5

Ethernet Remote Control

To remote program a DC Power Supply via a PC with Ethernet interface, it needs to confirm
the IP address, Gateway address and Subnet mask in advance. To ensure reliable data
transmission, TCP is used for data transmission and the communication port is 2101.
5.2

GPIB Function of 62000H Series

GPIB Function
Talker/Listener
Service Request
Remote/Local
5.3

Introduction to Programming

All commands and response messages are transmitted in ASCII codes. The response
messages must be read completely before a new command is sent, or the remaining
response messages will be lost and cause a query interrupt error.
Master (PC)
Table 5-4
Commands and response messages can be sent and received
over the GPIB bus. Status information can be read using a series
poll.
It sets the SRQ line to true if there is an enabled service request
condition.
Power-on in local mode, the front panel can be operated and the
commands are responded through GPIB. When in remote mode,
all front panel keys are invalid except
return to local mode.
Slave 1 Slave n
(62000H) (62000H)
Description
LOCAL
. Press "
Remote Operation
LOCAL
" can
5-3