Setting Ext._Trig Pull; Setting Prog No; Setting Run Count - Chroma 62000H Series Operating & Programming Manual

4.1.1.1

Setting EXT._TRIG PULL

1. Use " ", "
4-3 (1) shows.
2. Use numeric keys
3. Press " " to confirm.
ENTER
4. Press " " to return to Figure 4-1.
EXIT
1.
2.

4.1.1.2 Setting PROG NO.

1. Use " ", "
(2) shows.
2. Use the numeric (
3. Press " " to confirm.
ENTER
4. Press " " to return to Figure 4-1.
EXIT
Since there are 10 programs for setting, the valid range of PROG NO. is 1 ~ 10.

4.1.1.3 Setting RUN COUNT

1. Use " ", "
(3) shows.
2. Use numeric keys
" keys to move to the cursor to the column to be set as Figure
0 1
~ or "Rotary" (
When the EXT._TRIG PULL is set to HIGH, the user has to input a
negative edge trigger signal (TTL level) from the Analog Interface
PIN 8 on the rear panel to jump to the next sequence.
When the EXT._TRIG PULL is set to LOW, the user has to input a
high level signal from the Analog Interface PIN 8 on the rear panel
and change it to low level signal (negative edge trigger) to jump to
the next sequence.
" keys to move the cursor to the column to be set as Figure 4-3
0 9
~ ) keys or "Rotary" (
Figure 4-3
" keys to move the cursor to the column to be set as Figure 4-3
0 9
~ or "Rotary" (
Program Sequence
) to set HIGH or LOW.
) knob to set the value.
) knob to set the value.
4-3