Chroma 62000H Series Operating & Programming Manual page 25

10. The maximum drift of output power after warmed up for 30 minutes
and 8 hours test period when the input, loading and ambient
temperature are fixed.
11. The change caused by the ambient temperature per centigrade
when the input and loading are fixed.
12. Over 50% of maximum output voltage and the loading slew rate is
1A/us for rise and fall.
13. Either Ethernet or GPIB can be selected when shipping.
14. Please consult with the manufacturer.
15. Varied by local voltage regulation, all models in the 62000H Series
5kW, 10kW, 15kW have 200/220 Vac, 380/400 Vac and 440/480
Vac 3 types of input voltage for selection. Users can follow the local
voltage regulation to select a proper voltage spec. The Power
Supply is set with the required input voltage when shipped and
when the input voltage is not within the range, it will show AC_fault
protection and shut down the output.
16. It is the chassis size without any accessories.
17. The output voltage for operating the power supply should be larger
than 5% Full-scale.
1. If it is applied to battery charge or inductance load such as motors,
CAUTION
the output port needs to connect a diode in series to prevent the
load current from backwash and damage the device interior, see
Figure 1-1
2. For switchable power load applications, if the output load cable is
longer (>20cm) it is suggested to strand the load cable and parallel
the capacitance at the load power input to prevent any unexpected
oscillation from occurring, see Figure 1-2
Figure 1-1
Figure 1-2
Overview
1-9