1.
2.
3.
3.3.4.2 DISPLAY SELECTION
The setting of DISPLAY is to show the internal settings on the last line of MAIN PAGE for
easy identification without entering the setting page. There are 4 options available for
displaying on the MAIN PAGE: (1) NONE, (2) V/I LIMIT, (3) V/I/P PROTECT and (4) V/I
SLEWRATE.
1.
In Config setting page, press "
DISPLAY SELECTION as Figure 3-55 shows.
B R I G H T N E S S
D I S P L A Y
R E A D I N G
2.
Use "
", "
shows.
3.
Use the numeric keys (
setting. There are 4 selections on the MAIN PAGE:(1)NONE, (2)V/I LIMIT, (3)V/I/P
PROTECT and (4)V/I SLEWRATE. The system default is NONE.
When the selection is set to NONE, the MAIN PAGE does not show any message on
the last line.
When it is set to V/I LIMIT, the MAIN PAGE last line will show the range set by V LIMIT
and I LIMIT in OUTPUT SETUP as Figure 3-56 shows. See section 3.3.2.1 and 3.3.2.2
for detail description.
There are 3 selections for BRIGHTNESS: HIGH /NORMAL/
DIMMED, the default is HIGH.
Shortcuts and brightness description:
0
a.
Press "
", BRIGHTNESS = HIGH.
1
b.
Press "
", BRIGHTNESS = NORMAL.
2
c.
Press "
", BRIGHTNESS = DIMMED.
The lower backlight brightness, the longer the display panel life.
Thus, it is suggested to turn the backlight brightness to DIMMED
when the device is doing burn-in to prolong the product life of VFD
display.
4
" to display the screen and "
S E L E C T I O N
A V E R A G E T I M E S
Figure 3-55
" keys to move the cursor to the column to be set as Figure 3-55
0
3
~
[ D I S P L A Y S E T U P ]
= H I G H
= N O N E _
= 1
) or "Rotary" (
) knob to select the desired
Manual Operation
" to enter into
ENTER
3-33