Chroma 62000H Series Operating & Programming Manual page 146

Programmable DC Power Supply 62000H Series Operating & Programming Manual
Query Syntax:
Return Parameter: MASTER | SLAVE1 | SLAVE2 | ...... | SLAVE9
Query Example:
Return Example:
Note: CONFigure:MSTSLV? must be OFF when setting it. (Not in series/parallel mode.)
14. CONFigure:MSTSLV:PARSER
Description:
Syntax:
Parameter:
Example:
Query Syntax:
Return Parameter: PARALLEL| SERIES
Query Example:
Return Example:
Note: CONFigure:MSTSLV? must be OFF when setting it. (Not in series/parallel mode.)
15. CONFigure:MSTSLV:NUMSLV
Description:
Syntax:
Parameter:
Example:
Query Syntax:
Return Parameter: <NR1>
Query Example:
Return Example:
Note:
1. CONFigure:MSTSLV? must be OFF when setting it. (Not in series/parallel mode.)
2. Only 1 slave can be set when in series mode and maximum 9 slaves can be set
when in parallel mode.
16. CONFigure:MSTSLV
Description:
Syntax:
Parameter:
Example:
Query Syntax:
Return Parameter: ON| OFF
Query Example:
Return Example:
Note 1: Set the following 3 command before controlling this function:
CONFigure:MSTSLV:ID
ONFigure:MSTSLV:PARSER
CONFigure:MSTSLV:NUMSLV
Note 2: When Program RUN is executed, series/parallel control is not available.
5-14
CONFigure:MSTSLV:ID?
CONF:MSTSLV:ID?
MASTER or SLAVE1~SLAVE9
It sets to series or parallel mode.
CONFigure:MSTSLV:PARSER PARALLEL
CONFigure:MSTSLV:PARSER SERIES
PARALLEL| SERIES
CONFigure:MSTSLV:PARSER PARALLEL
CONFigure:MSTSLV:PARSER SERIES
CONFigure:MSTSLV:PARSER?
CONF:MSTSLV:PARSER?
PARALLEL
It sets the number of SLAVE to be controlled.
CONFigure:MSTSLV:NUMSLV <NR1>
<NR1>
CONFigure:MSTSLV:NUMSLV 1
CONFigure:MSTSLV:NUMSLV 2
CONFigure:MSTSLV:NUMSLV?
CONF:MSTSLV:NUMSLV?
1
It executes the Master/Slave control.
CONFigure:MSTSLV ON
CONFigure:MSTSLV OFF
ON | OFF
CONFigure:MSTSLV ON
CONFigure:MSTSLV OFF
CONFigure:MSTSLV?
CONF:MSTSLV?
ON| OFF